Radial Reamp JCR

The Original Reamp Circuit
The Reamp® JCR is a high-performance passive Reamper that gives you the ability to take a pre-recorded track and send it through a guitar amp or pedal chain, allowing you to explore new sonic textures and experiment with microphone placement, amp and pedal settings without limit. The JCR utilizes the original Reamp circuit designed by recording industry legend John Cuniberti, providing exceptional audio quality that preserves every detail of the original recording while optimizing it to feed amplifiers and effects pedals.

• Lets you re-record tracks through a guitar or bass amp

• Original Reamp® circuit designed by John Cuniberti

• Easy to use, Plug-and-play passive design

• Improves productivity while expanding creative options

Play now, perfect later
The Radial Reamp JCR is the latest version of the original Reamp that was designed and patented by John Cuniberti. It features a 100% passive design with John's original custom wound 'Made in the USA' transformer and circuit. The latest Radial version features separate XLR and ¼" TRS input connectors, variable output level plus a three-position filter that lets you tame excessive highs, warm up the lows or simply bypass if you want to revert to the original circuit. An on-board mute function has also been added to allow you to shut off the signal going to the amps when making adjustments or moving mics around the studio.

FEATURES

1/4" TRS Input
Connects from your recording workstation and is suitable for both lo-Z and hi-Z sources. Wired in parallel with the XLR.

1/4" Output
Unbalanced instrument level output connects from the JCR to amps and effects. Transformer isolated to eliminate hum and buzz caused by ground loops.

Mute
Silences the 1/4" output from the JCR going to the guitar or bass amplifier.

Filter
3-position switch with high-cut to warm overly bright amps, low-cut to clean up low end mud or bypass to go back to the original reamp circuit.

Level
Used to control the signal level going from the JCR to the guitar or bass amplifier.

Phase Invert
Flips the polarity at the output to compensate for amps or effects that invert the phase of the signal.

Ground Lift
Disconnects ground at the input to eliminate hum and buzz caused by ground loops.

XLR Input
Balanced input, connects from the output of your recording system to the JCR.

SPECIFICATIONS

Audio circuit type: Passive, transformer isolated
Frequency response: 20Hz ~ 20kHz (+0dB/-1dB)
Dynamic range: 140dB
Total harmonic distortion: 0.001% @ 1kHz/0dBu input
Intermodulation Distortion: 0.0025% @ 1kHz/-10dB input
Phase Deviation: 2º @ 100Hz; 0º @ 800Hz
Input Impedance: 1800 Ohms
Output Impedance: 4.8k Ohms
Common Mode Rejection Ratio: -55dB @ 55Hz
Noise Floor: -115dBu
Maximum Input: +26dBu
Controls: 180° polarity reverse, Ground lift, HPF, LPF, Level Control
Input Connectors: 1/4" TRS, XLR
Output Connectors: 1/4" unbalanced
Construction: 14-gauge steel chassis & outer shell
Size (L x W x D): 3.3" x 5.0" x 2" (84 x 127 x 48mm)
Weight: 1.32lb (600g)
Shipping size (L x W x D): 4" x 3" x 6.5" (102 x 76 x 165mm)
Shipping weight: 1.85lb (840g)
Power: Passive, no power required
Conditions: For use in dry locations only between 5°C and 40°C
Warranty: Radial 3-year, transferable